RailPro > RailPro Specific Help & Discussion

Atlas C420 Install

<< < (2/3) > >>

sandy.hadsell:
Kevin,

Thank You, I ordered some 8 to 9 harnesses from Yankee Dabbler late last week. Should be here this week. If there is not enough room, I can hardwire everything direct and just skip the board? Any issues with the headlights? Is the motor already insulated, and I can just wire direct to the motor leads? Sorry for all the questions. I'm sure when I get the first one up and running, the rest will go easier.

sandy.hadsell:
I was successful installing the PWR-56 on my layout and the Lm-3S in the Atlas C420. I put the original board back in, used the 8 to 9 pin harness and a 10mm round MRC speaker I bought on ebay for a buck. I have lights sounds, and successful motion on the first try. I have a few dead spots in track work that will need my attention, and larger speakers for future installs would be better, but I am happy that everything worked on the first try. Thank you to the RailPro users who offered advice and encouragement.

sandy.hadsell:

sandy.hadsell:
Everything wired up.

sandy.hadsell:
Taped in place. Ready for shell.

Navigation

[0] Message Index

[#] Next page

[*] Previous page