RailPro > RailPro Specific Help & Discussion

Atlas problems

<< < (2/2)

nortoneye:
Yes,  I only used one wire from each truck for the power leads (opposite sides of course)  I did insulate the motor from the frame but there is a mounting screw that I am suspicious of now that I think of it.  I'll check that and wire in both sides of the trucks to the proper sides.  Thanks for the advice guys.  I'll post an update after done

nortoneye:
after careful review, i found some binding in he drive gearing and was able to resolve the intermittent loss of power-life is good

Navigation

[0] Message Index

[*] Previous page