RailPro > RailPro Specific Help & Discussion

Engines speed slowing down

<< < (2/5) > >>

SWA737:
 I did the railpro conversion about four years ago. This just started recently.  I have a couple of Athearn Genesis engines I will try and see what happens there. Have not run them for a little while. That may tell the story.  I’m assuming if it’s a decoder problem, I would probably get the overload fault or overheat on that perhaps on the HC2?

Alan:
Pet fur in the mechanism maybe?

nodcc4me:
That leads me to believe the modules are not the problem, nor the older engines. Check the track voltage with a meter.

SWA737:
14.2 volts in all 4 power Districts with 2 different meters. No pets in house. Really a mystery. Thanks for all of the thoughts and suggestions.

William Brillinger:
Is that track voltage test when the issue is happening? If not, check it then also.

Navigation

[0] Message Index

[#] Next page

[*] Previous page