RailPro > RailPro Specific Help & Discussion

Electro Couplers in RailPro

(1/1)

ron045:
I'm starting my 2nd install.  I am upgrading an O scale MTH proto 1 GP38.  That model has electronic proto couplers. 

I can't get RP to fire the coupler with the +5v.  I have read those older MTH couplers need 12v.

Has anyone successfully hooked up electro couplers?

Thanks.
Ron

KPack:
You can always look into a voltage step-up converter.  Pololu makes some that are small are easy to use.  I had to use a 3.7 to 12 volt converter for my battery powered locomotive.  The battery only puts out 3.7 volts but the LM needs 12-14.  Works like a charm.

For your situation, you could put one on the output wires going to the couplers.  As far as I know that should work.

-Kevin

ron045:

--- Quote from: KPack on August 06, 2021, 12:06:27 AM ---You can always look into a voltage step-up converter.  Pololu makes some that are small are easy to use.  I had to use a 3.7 to 12 volt converter for my battery powered locomotive.  The battery only puts out 3.7 volts but the LM needs 12-14.  Works like a charm.

For your situation, you could put one on the output wires going to the couplers.  As far as I know that should work.

-Kevin

--- End quote ---

I never heard of such a thing.  I'll look into it.  Thank you.

ron045:
Is this it?

https://www.amazon.com/Pololu-Step-Up-Step-Down-Regulator-S10V2F12/dp/B016YSK3VC/ref=sr_1_3?dchild=1&keywords=pololu+voltage+converter&qid=1628250578&sr=8-3

Alan:
Or simply a small 5V coil relay.

Navigation

[0] Message Index