RailPro > RailPro Specific Help & Discussion

New Problem

(1/2) > >>

Josephbw:
I dug out one of my old engines from my previous layout back in the 70's. It's an old Athearn SD9, that is still in pretty good condition. I installed the LM2s and wired everything up, then put it on my programming track. I hit "Find Product", and it found the LM. Then I went to advanced setup and gave it a name and number. When I try to select it it is nowhere to be found, either in the select loco page or the Loco List.

It's been so long since I did an initial setup that I'm sure I missed something. The instruction book dosen't seem to cover the initial programming, at least as I've been able to find.

Any ideas?

Thank you,
Joe

KPack:
The picture doesn't show up at all?  It could be the ghost module thing we ran across a while back, although I can't remember how it was resolved.

-Kevin

ON28:
Does the loco motor have to be isolated from the frame for RP to function?

Josephbw:

--- Quote from: KPack on August 09, 2021, 01:00:09 PM ---The picture doesn't show up at all?  It could be the ghost module thing we ran across a while back, although I can't remember how it was resolved.

-Kevin

--- End quote ---

No picture at all, nor anything other than it found the decoder when I search for it.

I'll see if I can find the ghost thread.
Joe

Josephbw:
I just did a search for ghost module, and it only came back to this thread. :(

Navigation

[0] Message Index

[#] Next page