RailPro > RailPro Specific Help & Discussion

Control taken away!

(1/1)

ON28:
My Intermountain F3 was running fine. I unlinked it from a consist, and ran an update of the LM3-S software, not noticing it had already been updated. When I then selected the loco on the HC, its page came up but immediately prompted me that buttons had been revised and to go to Adjustments and save. I exited back to the loco page but when trying to access Adjustments, I got a message "Control taken away!" I could not acquire or re-consist it and got a "Bad lead loco" message. I tried clearing the loco from the HC and re-acquiring, but got the same messages.

Any suggestions here are gratefully accepted before I call Ring. Thanks!

nodcc4me:
It's probably just a glitch. Try unlinking any other locos that are in the consist. Then power off the system and turn it back on and try to access the LM3-S again.

ON28:

--- Quote from: nodcc4me on December 20, 2021, 05:35:55 PM ---It's probably just a glitch. Try unlinking any other locos that are in the consist. Then power off the system and turn it back on and try to access the LM3-S again.

--- End quote ---

Yes, seemed to be a glitch, all's well now. Thanks.

Navigation

[0] Message Index