RailPro > RailPro Specific Help & Discussion

Prime Mover download issue

(1/2) > >>

Davidbross:
I have been unable to get the prime mover file gevo 12 tier ult to download successfully into an engine.  I have tried the HC simulator and a physical remote.  The file downloads for a while and then says cannot connect to locomotive.  The engine is within 12 inches of the computer when I use the HC simulator and right next to the remote when I try that way.  I have tried three different engines.

JRad:
I think I recall having this problem a while back.  Not certain how I solved it, but I think I figured that the file was too big for the space in the module, so I deleted un-needed sounds from the module first, then tried again.  Eventually it loaded.  ULT files are huge by comparison to standard sounds!

William Brillinger:
Yup, you'll need to remove any existing prime mover files from the module. Try again and see if the problem is resolved.

Davidbross:
Thank you.  I was afraid to remove my prime mover in case I had an issue getting one in.  I'll try it!

Davidbross:
Deleting the other file before putting in the new one seems to have done it.  I won't know until the speaker I am waiting on shows up.

Navigation

[0] Message Index

[#] Next page