RailPro > RailPro Specific Help & Discussion

Fitting a LM-2S in a HOn3 brass tender

(1/1)

ngdave28:
Hello everyone.  I have a brass tender that I am looking to install a LM-2S into.  Dimension inside tender are 1.0" wide by 1.75" long by 0.43 high.  I understand LM-2S is 1.5" long.  With both 9 pin and 6 pin plugged in and leads bent up at right angles, will this fit in the 1.75" dimension?

Another problem is that tender is entirely brass sheet metal.  I plan to replace floor with styrene and open top where coal load is for speaker output.  Hopefully this will be enough for RF reception.

Any thoughts will be appreciated.
Dave

Navigation

[0] Message Index