RailPro > RailPro Specific Help & Discussion

Low voltage warning

<< < (2/4) > >>

roofintrash:
If you mean the draw test when you first set them up,,yes. Even re did it to make sure.

William Brillinger:
well, I'm stumped.  I've only seen low voltage messages when I have the loco too far away from the power supply and adding more bus wire fixed that.

roofintrash:
The other strange thing, is if I have the status screen up while the loco is running the voltage bar doesn't change but the status message will still change between OK no faults and low track voltage. Zero change in speed or performance.

roofintrash:
This will happen 2" away from the power supply or 20' from the supply. Also happens in both power districts.

Alan:

--- Quote from: roofintrash on December 23, 2015, 09:32:50 AM ---The other strange thing, is if I have the status screen up while the loco is running the voltage bar doesn't change but the status message will still change between OK no faults and low track voltage. Zero change in speed or performance.

--- End quote ---

I see the same.

Navigation

[0] Message Index

[#] Next page

[*] Previous page