RailPro > RailPro Specific Help & Discussion

Turnouts HC icon

(1/3) > >>

mcbunton:
I'm sure this is a dumb question but perhaps you will humor me.

Using AM-! to control turnouts on dead rail outdoor setup.  I have them working fine but the switch picture or icon or whatever the proper work is on my HC is exactly opposite of what the turnout is actually set to.  I.e. if the turnout has the train going straight thru the picture shows the switch set to turnout instead, and the opposite.

Sorry if not describing this correctly.   But is there a solution?

nodcc4me:
Try moving the switch manually once, then try the HC again. That may fix it.That has happened to me a few times.

Dodgezilla04:
Could you tell us how you're using the ac1 to control turnouts please? Such as what's activating the turnout

Thank you

Jim Agnew:
Try reversing the wires at the AM-1.

mcbunton:
Outdoor layout, 5 AM-1 scattered around 600 ft plus of track, each powered by a twelve volt battery and controlled by HC-S.

Thanks for replies so far.

Navigation

[0] Message Index

[#] Next page