RailPro > RailPro Specific Help & Discussion

Can't unlink

<< < (2/2)

G8B4Life:
Yes but is the firmware up to date? The latest for the HC-3 is 1.09 and for the HC-2 is 2.52 . Also worth checking the LM's are up to date as well.

Now, a question I thought of after I had previously answered; have you had them linked, either to each other or to other locomotives, previously? If you've had them linked together or either of them to a different locomotive previously and you didn't unlink them before removing the track power / turning off the HC it might be possible that caused problems; there was something similar in the past though the clear active loco list button was introduced to deal with that issue which you've done.

- Tim

mcbunton:
except for bad luck, I wouldn't have any luck at all

New HC3, went to add a loco I didn't have on it, it has been searching for product for an hour and a half, and no button I push gets it to stop, plugged into charge, still searching.  Plugged into computer to see if that would stop it, Nope.  Still searching

HC2 have tried to update 3 times, it shows progress bar all done, computer shows files all 100%. but it still shows hardware 2.05 as it did before starting instead of the 2.52 upgrade.

mcbunton:
Update, let the HC3 search till it drained the battery, recharged and it's working fine.

The HC2 turned out to be a HC2b even though the label on it said nothing about b.  Ran the update for HC2b and now have version 2.52.

Back to the link problem now.

snowdog:
Try removing the offending locos from all of your HC's. Remove power from the locos for about 5 minutes. Add first loco to ONE (1) HC, once successfully found and setup, operate as a single unit for a short bit...5 minutes.  Add second loco and repeat. Then MU them, once successful, unlink and then repeat the process for the second HC.

Have fun!

Navigation

[0] Message Index

[*] Previous page