RailPro > RailPro Specific Help & Discussion

Lights causing LM-3S to overheat?

(1/3) > >>

CPRail:
Hi Group,

I was test running my latest install (an Athearn SP SD45T-2) under load (about 25 cars running in tandem with a Rapido B36-7), and got a heat warning from the LM. First time I've ever gotten one. Basement is pretty cool these days in the Great White North, so ambient temperature wouldn't be an issue.

I did some testing and the temperature starts rising when I turn the lights on. I have the front headlight and the front gyralite wired up - both using 1.5V bulbs as I didn't want to fart around with LEDs and resistors (and I had spare bulbs).

I can't images 4 x 1.5V bulbs being that big of a draw to cause a heat warning, but even not moving you can see the heat increasing.

Install is a LM-3S plugged into the Athearn board, Scale Sound Speaker, TCS KA-4. The bulbs are wired to the front and rear headlight connections on the board, with the rear for the gryalites as there are no other connections on the board.

Any ideas?

G8B4Life:
Is the Athearn board set up for 1.5v globes? and how have you wired the pairs of globes, series or parallel? The temp rising is indicative of the globes drawing to much current.

A quick test you can make is to turn the brightness way down, effectively limiting the current to almost nothing and see if the temp rises as quick.

I'd also go over the wiring very carefully to make sure there isn't an error that could cause another path for current to flow instead of just through the globes.

- Tim

gregeusa:
does the decoder use full input voltage, and then uses pwm to "lower" the effective voltage?

Espeelark:
I had that exact same thing happen with my stock Athearn SP GP40X. Discussed it here in my "Module Over Temperature" thread:
https://rpug.pdc.ca/index.php/topic,1176.msg9000.html

After I replaced the incandescent bulbs with LEDs the problem went away.

CPRail:
Morning All,

Below are answers to all the questions:
* The lights are the same as came with the loco - the little 1.5v bulbs with the miles of wire that Athearn used to stuff in their locos.
* They are wired in parallel.
* I'm not sure what gregeusa is asking about full input voltage and pwms. The LM is plugged into the Athearn board and the lights are activated using the RP recommended wire colour.

 

Navigation

[0] Message Index

[#] Next page