RailPro > RailPro Specific Help & Discussion
LM-3S-21 Module compatibility with different manufacturers
LVRR1856:
I just ordered a small drill press and a milling table, figured I invested a few bucks in the RP system and definitely know to fit them into most HO locos .... "Some Milling Required" - this should help the process. I've seen many dcc installs cutting frames and weights as well - so, to be expected.
faithie999:
--- Quote from: gregeusa on August 15, 2025, 05:51:38 PM ---fathie999: I'm confused.
Since this thread is on the 21 pin version of RP decoder... if you remove all the circuit boards, do you wire in a new 21 pin plug so you can connect to the RP 21 pin module?
--- End quote ---
shame on me!! i responded too quickly and overlooked that significant detail! i see that in a subsequent message another member gave the right info.
sorry!
Ken
Navigation
[0] Message Index
[*] Previous page
Go to full version