General > General Discussion
Finally have some pictures....
Josephbw:
In this view I have started the middle island on the far wall. You'll note the supervisor chair for when my minions need direction. ;D
Josephbw:
In this shot I have built the framework for the circle and also started the framing for the industrial park. The door to the right is for the bathroom I had to build. You know, old men and their bladders. :(
BTW, I'm the minion, but I have a couple of friends that have also helped me when I need them. I'll do more pics tonight or tomorrow when I get time.
Joe
Josephbw:
--- Quote from: nodcc4me on April 27, 2016, 03:35:43 PM ---That is going to be a huge layout Joe. Have you drawn it out yet?
--- End quote ---
I drew out the outline, the towns, and the general proportions. I didn't have the buildings yet when I drew it out, so I wasn't sure which buildings I would have to kitbash and didn't have the dimensions, so I basically winged it. I put down a circle of track so I could break in my engines and test them after module installations. But that is only temporary. I have now started laying permanent trackage and just put up the viewblock down the middle of the island. I have a long way to go, but I make progress every day.
Joe
William Brillinger:
--- Quote ---I was wondering about the (MSG) code =24 at the end of the instruction line. The way I interpret the codes, is that the (width) adjusts the width of the image. Or did I misinterpret that?
--- End quote ---
You are correct, the width parameter sets the width to use to display your image, measured in pixels.
Height is automatically calculated based on the given width.
The msg=24 code is what the software uses to correlate your picture to your post.
In the case of your original post here, the msg number is 1157.
24 is the number of the "how to post an image" tutorial.
In this link you will see the msg number in use: http://rpug.pdc.ca/index.php?topic=210.msg1157#msg1157
And this one links to the tutorial: http://rpug.pdc.ca/index.php?topic=11.msg24#msg24
Josephbw:
This pic shows the cross bracing installed.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version