RailPro > RailPro Specific Help & Discussion

RailPro HC-2 Throttle Holder Design

<< < (3/4) > >>

Josephbw:
Good job Bill. One thing I didn't think about before was countersinking the screws. Will there be enough meat left in the hole to prevent tearing out the hole if someone gets a little rough with it or it gets bumped? I was thinking about an extra back piece to make it thick enough to handle the screw head better. Or if the wood is tough enough already, that wouldn't be needed. I'll probably need one for each of my control panels.

Thanks, Joe

William Brillinger:

--- Quote ---One thing I didn't think about before was countersinking the screws
--- End quote ---

Joe, the hole is not tapered, but using a countersinking screw in it is fine.
Just snug it up and the head will be into the foam.

Josephbw:
I just downloaded your file for the box, and I see what you did now. That should work fine. I'll send you an order.

Thanks again,
Joe


Hey, I'm a full member now, YEAH  ;D

Josephbw:
Bill, I just went to the order page and it's showing 5 for $60. Can I send the order in and you will adjust it, or how should I do it?

William Brillinger:
Hi Joe,

Sorry I had not posted the 5 pack, I forgot to set it up!
It's now listed on the same page: http://pdc.ca/rr/catalog/product/railpro-hc-2-throttle-holder/56

Navigation

[0] Message Index

[#] Next page

[*] Previous page