RailPro > RailPro Specific Help & Discussion
Keep Alive installation w/ Railpro
TwinStar:
--- Quote from: Alan on December 08, 2017, 04:44:51 PM ---
--- Quote from: TwinStar on December 08, 2017, 04:33:16 PM ---Where did the KA install with bridge rectifier diagram go? I can't find it after the rearrangement.
Thanks.
--- End quote ---
Bill's Nov 9 reply two replies above yours in this thread.
--- End quote ---
I apologize. I was looking for a drawn diagram and completely glossed over that. :-[
William Brillinger:
No Worries Jacob!
And I agree with Kevin, the KA's work as advertised and the Bridge Rectifier does not cause any issues when MUing with units that do not use them. All of my Locos are KA equipped.
EsselW:
I had been considering RailPro with the Stanton BPS for control on a small On30 layout. But would RailPro with a keep-alive pretty much work as well? There wouldn't be any lengthy un-powered sections, just dirty nickel silver track, insulated un-powered frogs, and slow speeds.
KPack:
I don't see any reason why it wouldn't. The keep-alive's (especially the larger ones) can last for a good amount of time, depending on how much current your motor is drawing. I'd say wiring up a KA is easier and takes up less space than the Stanton BPS. It's certainly worth a try.
-Kevin
Alan:
Your keep-alive equipped loco still doesn't have enough juice to get across all that dirty track? Maybe a laxative will help.
https://phys.org/news/2019-08-supercapacitors-turbocharged-laxatives.html
Keep you eye peeled for ionic electrolyte super capacitors coming onto the market. Maybe your next keep-alive will run for hours!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version