RailPro > RailPro Specific Help & Discussion
Keep Alive installation w/ Railpro
TwinStar:
--- Quote from: KPack on February 15, 2017, 03:28:42 PM ---No, I checked and it's set to HO. I flipped it to N a few times while I was over there running and that put it right on target. Problem is when I do that it messes with all his settings on his reverse loops. So I just run on the high voltage and keep an eye on the module temps. Never had an issue with it, which speaks to Ring's engineering on the LM.
-Kevin
--- End quote ---
That's interesting. All we run on top of with Free-mo is Digitrax. I haven't seen voltages that high that I can recall.
TwinStar:
I successfully installed my first KA into a Proto E7 last night. Everything worked great. I appreciate all the info posted on this thread in order to make this happen. It is pretty cool pulling the loco off the track and watching it run across the table on no rails! I'll continue installing them in my other E units tonight.
nodcc4me:
Jacob, if possible, would you please post a photo of your install. IIRC the Proto E7 didn't have much room. I had to remove the factory board just to fit the LM in there. I see that the KA-4 is much smaller than the KA-3. Is there any reason not to use the KA-4?
While we are discussing KA, BLI Blue Line locomotives have KA capacitors installed alongside the circuit board, which also have 8-pin connectors. Has anyone installed an LM in a Blue Line loco? If so, does the KA do the job?
TwinStar:
Al:
I'm trying but apparently I can't load photos here for some reason and it's been so long since I've had to use image hosting that I can't remember who I used to use.
I'm not ignoring the request but trying to remember how to do this.
Jacob
Alan:
Bill has you covered. Posting pictures: http://rpug.pdc.ca/index.php/topic,11.0.html
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version