RailPro > RailPro Specific Help & Discussion

Install LM-3 Bachmann S-2 Diesel Switcher

<< < (2/2)

darryl.trains:
Bill

 I was lucky enough to put the cab on as there was not one mil to spare after fitting the module under the circuit board. I had thought about cutting the cell phone speaker in two pieces so it would be half as long and it might fit near the end of the circuit board. I am considering taking out the circuit board and see what matures then. Onward into the unknown..  TOF

KPack:
You'll have a lot more room after getting the factory board out of there.  That's the reason I take out all factory electronics in nearly all my installs.  Yes you have to hardwire in a harness, but it's so much easier to fit everything that way.

Kevin

Navigation

[0] Message Index

[*] Previous page