RailPro > Finished RailPro Installation Examples

Scaletrains SD40-2 install

<< < (2/2)

BruceRogers:
Ed, I used the TCS 1352 1 inch harness. It's all the hobby shop had and it works fine.
Bruce

Viper:
Cool thanks

Rtardif:
Just lookin for some advise, i hard wired a Lm3s Into a scaletrains sd40-2 but i cannot get the beacon light to work through the lm3s. Light works when tested on the rail but not through module. I have tried swapping the polarization also. Thanks Ray

BruceRogers:
I had to remove the circuit board in the cab roof. There's something in the board that allows Scale Trains to have different light effects for various railroads. I've been meaning to send it to Ring to see what he can figure out.

Rtardif:
Yeah i cut the wires to that little circuit board in the upper shell and wired then via micro connectors to the green output on the 6 pin side of the LM3S. I got it to work with the double strobe effect. Pretty cool. So i got all the lights working minus the red class lights (ran out of outputs on the LM3S). Pretty easy Loco to hardwire.

Navigation

[0] Message Index

[*] Previous page