RailPro > RailPro Software Updates
NEW: Dual Mode (DCC), ULT Sounds, Load/Brake Dynamic Momentum Features Avaialble
William Brillinger:
--- Quote ---I suspected as much. Looks like I'll be using the old sounds.
--- End quote ---
Why?
The new sounds run perfectly well on the LM-2S and LM-3S after the programs for both the HC's and the LM's are updated.
KPack:
No, you shouldn't have to use the old sounds. Make sure the LM is fully updated and it should work fine. The newest programs are on RPA. What program revision does the LM show? It should be 2.02. You can find it on the locomotive control screen, under the "info" button. When you buy modules they are typically not at the latest software revision. Software revisions are constantly released and the modules that have been sitting in stock for some time will be at a much older revision. The very first thing I do when installing a new module is update the software to the latest revision.
I'm not sure it's possible to to load the wrong file into an LM. It should prevent itself from doing it.
-Kevin
Morebassman:
I'm a little confused! Do I have to download to my my #HC-2 hand held controller first to HC-2 Rev-2-02? Then download the LM-3S Rev 2-02?
William Brillinger:
The order you download them should not matter, but they both must be installed for the new functions to work properly.
MustDecide:
--- Quote from: William Brillinger on September 27, 2017, 03:16:47 PM ---I really recommend using the CI-1 with the HC-Sim for loading files to LM's.
This lets you work completely on the computer and not tie up the HC for what can be hours.
It's much faster to use the HC-Sim and you don't have to worry about the battery on your HC.
Once you have the files loaded on an LM then you can use the HC to configure the LM while you're loading programs to your next LM from the HC-Sim software.
The CI-1 is really invaluable - especially as the programs & sounds get larger.
Don't forget to update the RPA software, then the HC-Sim and HC software, then load the new files to your LM's.
--- End quote ---
I can get the files to download through the HC-2b but I cannot get the CI-1 to work it just keeps saying that it cannot connect to the internet. I did turn off my virus checker already. Also I downloaded what I thought was the latest version of software for the HC-2 but it did not affect the way the screen looks. I thought it would show the DCC options.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version