RailPro > RailPro Specific Help & Discussion

Scale Trains Tier 4 Install

(1/2) > >>

CampbellRice:
I just purchased a new Scale Trains Tier 4 Gevo. I have not taken it apart as of yet but I notice the instructions say it has a new LokSound decoder that has dip switches on it. Has anyone looked at how to install a RailPro into this unit yet?
My eyes and electrical experience does not exceed much past plug and play.

nodcc4me:
I haven't done one of those, but you will most likely have to remove the decoder and hard wire it to take advantage of all the features of RailPro. The speaker is already in there but you would need to wire that as well.

Viper:
do they also have the 9pin to 21 connector like the ST SD40-2's ?
Ed

CampbellRice:
I ended up sending mine to Litchfield Station for the install of the RailPro and a Keep Alive. They did a very good job.

nodcc4me:
Did you provide the module and KA or did you have to buy them from Litchfield? If you don't mind saying, how much did it cost?

Navigation

[0] Message Index

[#] Next page