RailPro > RailPro Specific Help & Discussion

Took the plunge

(1/5) > >>

Edavis:
Not sure if iam writing this in the right place or not but I took the plunge and ordered starter kit and 3 modules one with sound is there anything thing else I might need to run.All I run with now is tech2 hooked up with the two wires.Totally new at any kind of control other than what I have now.Any help,tips,would be great.thx

Alan:
Welcome to the club. Sounds like you have everything you need to get up and running.

Edavis:
Ok thanks for the reply. I am looking forward to trying this

Alan:
Upon further thought...

If your locomotives are not DCC Ready labeled locomotives (no circuit board or wiring connector inside) then you will need a 9 pin harnesses to wire the LM to the locomotive.

http://www.ringengineering.com/Accessories.htm

Edavis:
I have one athearn quick plug and one Walthers  mainline and a athearn genesis.the quick plug I think I get but the  Walthers iam not sure didn't see a quick plug.the genesis I haven't opened yet I hope it has the plug.

Navigation

[0] Message Index

[#] Next page