RailPro > RailPro Specific Help & Discussion

21 pin

<< < (2/3) > >>

BruceRogers:
Today I used the 9 to 21 pin adapter on couple of locomotives. Yes you lose some lighting features. Athearn SDP40F, the red emergency and ground lights under the cab won't work. The Intermountain ES44AC the rear ditch (if equipped) and number board lights won't work.
Scale Trains SD40-2 the beacon and some of the class lights will not work.
It is possible to wire these lights off the rear outputs of the LM module by accessing the light wiring directly.

CPRail:
I used the TCS 21 pin to 9 pin harness for the Bowser SD40-2.

CPRail:
I cracked open the Bowser SD40-2 that I did an install in last night, and the lights for the numberboards and class lights were left intact. I cannot get them to turn on using the connections on the harness on the 9 pin side of the LM, so I suspect that you'd need to connect them to the 6 pin side to get them to work.

Antoine L.:
Thank you very much!

Antoine

Antoine L.:
Do you guys think the new Dash8-40cm loco from Rapido has enough space in fuel tank for Railpro module? Will it be an easy install?

If some of you try it, let us all know!

Antoine

Navigation

[0] Message Index

[#] Next page

[*] Previous page