Welcome to RPUG > New Users Start Here
Introduce Yourself...
nodcc4me:
Welcome Glenn, and thank you for your service.
If you are used to running DCC then you will love RailPro. It is much easier to use. Read through the threads on here when you have time. There is a lot of good information that will answer most of your questions including pictures, diagrams and installation tips.
Alan:
Welcome and thank you for your service.
KiloWhiskey:
Welcome... what is your MOS ? We have a few Cannon cockers here...
GMM6809:
--- Quote from: nodcc4me on March 06, 2020, 01:00:05 PM ---Welcome Glenn, and thank you for your service.
If you are used to running DCC then you will love RailPro. It is much easier to use. Read through the threads on here when you have time. There is a lot of good information that will answer most of your questions including pictures, diagrams and installation tips.
--- End quote ---
Thank you for your support, I have been lurking around and reading up on a bunch of this stuff, still trying to figure out what section different questions i have would be in, or best suited to ask the in. Loving the forum though!
--- Quote from: Alan on March 06, 2020, 01:11:41 PM ---Welcome and thank you for your service.
--- End quote ---
Thank you and i appreciate your support!
--- Quote from: KiloWhiskey on March 06, 2020, 08:27:46 PM ---Welcome... what is your MOS ? We have a few Cannon cockers here...
--- End quote ---
6153 Airframe Structural Mechanic on the CH-53E. 8)
POG and proud. Lmao ;D
William Brillinger:
--- Quote ---I have been lurking around and reading up on a bunch of this stuff, still trying to figure out what section different questions i have would be in, or best suited to ask the in. Loving the forum though!
--- End quote ---
Welcome!
Most questions should be asked in a new post under the RailPro Discussion & Help section.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version