RailPro > Finished RailPro Installation Examples
BLI Blue Line F7-A Installation Question
nodcc4me:
Has anyone done one of these? I am considering getting one, and wondering if there is enough room for a LM. Blue Line models already have a speaker installed.
TwinStar:
Al:
I installed in a BLI EB-7 and an E-8 but nothing smaller from them.
nodcc4me:
Jacob, did you have to remove the board and hard wire it or were you able to use the 8-pin plug?
TwinStar:
On the E8 I removed everything except the nose LED light board. I thought I had a thread here mapping that board as to which pad went to which light but I can find it right now. This is an LM-2S install with a Bridge Rectifier, KA-3, and two iPhone speakers.
Outside of the RailPro install I also replaced the BLI motor with a Kato and used NWSL drive components. You may want to look at the couplers as well. They were 0.040" too high and had to be shimmed lower. I don't know about their F units but they may have copied and pasted some elements in CAD.
William Brillinger:
Jacob, you have a post on the Proto 2000 EA-7 here: https://rpug.pdc.ca/index.php/topic,69.0.html
Navigation
[0] Message Index
[#] Next page
Go to full version