RailPro > RailPro Specific Help & Discussion
Re: Repeaters
Dean:
I believe the reason you need to 'find' the PWR-56 with the HC is the e-stop. One of the e-stop buttons is 'remove power' ( or something similar ). If you are not using a PWR-56, you can't shut off the power supply with the HC.
Alan:
--- Quote from: Dean on February 15, 2018, 12:03:59 PM ---I believe the reason you need to 'find' the PWR-56 with the HC is the e-stop. One of the e-stop buttons is 'remove power' ( or something similar ). If you are not using a PWR-56, you can't shut off the power supply with the HC.
--- End quote ---
That makes total sense.
@Bill or Tim - You might consider moving a bunch of this content to a new thread so we don't further trash out Ken's Open House topic.
William Brillinger:
I asked Tim Ring...
--- Quote ---Does the PWR-56 have to be setup as a repeater on the HC or will it be repeating by default?
--- End quote ---
Here is his answer...
--- Quote ---The first PWR-56 you Find will be added as a repeater. However the save button is not executed. So after you Find a PWR-56 you should press the save button. If you want more PWR-56 to be repeaters you should go and select the ones you want to be repeaters. Only PWRs in the repeater screen will do the repeating. If there is no PWRs in the repeater selection screen then no repeating will be done.
Tim
Ring Engineering Inc.
--- End quote ---
Ken Z:
I am finding out so many neat things about RailPro in these posts. I just need to be sure I can find it to keep it fresh while I am learning.
Ken Zieska
Navigation
[0] Message Index
[*] Previous page
Go to full version