General > General Discussion
Accessory bus
William Brillinger:
Just to round out the conversation from earlier, I received this update on the AM-1 from Tim at Ring Engineering:
--- Quote ---The AM-1 hardware actually has 16 outputs. However, there currently is only one hardware configuration that is supported by the RailPro Assistant Program. That configuration is 4 outputs and two motor outputs and 8 inputs.
You could use the two motor outputs to drive lights for a total of 6. You would set the motor to 100% (on) and 0%(off). These two lights would be on off only(no light effects).
--- End quote ---
Navigation
[0] Message Index
[*] Previous page
Go to full version