RailPro > RailPro Specific Help & Discussion

eratic operation

<< < (2/2)

Dean:
Is there any arching on the catenary or wheels?

Alan:

--- Quote from: Michael on April 11, 2018, 08:59:36 PM ---Problem:

I have converted 3 trolley cars to RP using the LM2-S module. The cars move about 3 inches, then stop; move 3 inches more than stop; move 3 inches  more than stop etc. Occasionally I receive the fault "low track voltage" but not continuously. The HC-2 shows track voltage at around 13.8 volts. The cars pull less than 1/2 amp. The module always runs cool.

Mike Sullivan

--- End quote ---

What you describe is indicative of the over-current protection kicking in and then resetting. Both LM and PWR have protection circuitry. Both permit brief over-current to allow for motor start-up (DC motors are a near short circuit before they begin to spin). Place a test light or multi-meter across the rails. If the light goes out when the trolley stops then the PWR is doing the protection. Conversely, if the light stays on then the LM is doing the protection. Either way too much current is being drawn for some reason. It is also possible your shoe/catenary contact is too high resistance.

The mention of arcing by Dean is a valid concern. Anytime a DC circuit is made or broken there is a voltage spike. Depending upon the inductance of the wiring and catenary the spike can be quite large potentially damaging the LM. Given that catenary will always have some arcing you may want to consider adding a bridge rectifier, capacitor, and zener diode ahead of the LM to protect it from the spikes.

Michael:

--- Quote from: Dean on April 12, 2018, 02:02:21 PM ---Is there any arching on the catenary or wheels?

--- End quote ---

Yes, unfortunately there is always arching on the catenary from the trolley shoe especially when it rolls over an overhead frog, or other overhead fitting. Very similar to the prototype. 

I don't think this can be avoided.  :(

Michael:

--- Quote from: William Brillinger on April 12, 2018, 06:51:00 AM ---13.8V is low. The PWR-56 should be around 14.5V.
Do you have a meter to check the voltage on the power bus at the PWR-56?

--- End quote ---

I recently purchased a multi-meter, but I'm not familiar with it's use. (I was absent from physics class the day it was covered). Let me check it out, and let you know.

Navigation

[0] Message Index

[*] Previous page