RailPro > RailPro Specific Help & Discussion

Problem with upgrades

(1/2) > >>

Dean:
I downloaded the latest program and accessory files for my LM-3s. I updated the program and accessory files in two engines. Now the HC-2 does not see one of the engines. I tried to 'find new product' and that failed. The engine disappeared. It's no longer listed in the 'Locomotive' index.
I updated the second engine while I waited for the 30 seconds. Now the HC-2 can see this engine and indicates that is connected to it, but none of the commands work. The engine won't run nor will any of the lights work.

Any suggestions?

William Brillinger:
Is the software for the HC up to date?

Dean:
Yes, the HC-2 was updated a few weeks ago.
I am thinking of trying the reset button on the HC-2.

What is strange is I have been updating my decoders for a few weeks now. The only difference is that on these two problem decoders, I added the 'accessory' files too.

William Brillinger:
Dean, Contact Ring before hitting that reset button.

G8B4Life:

--- Quote from: Dean on April 30, 2018, 08:04:26 PM ---I downloaded the latest program and accessory files for my LM-3s. I updated the program and accessory files in two engines.

--- End quote ---

If you downloaded the Accessory Program to the LM-3S then the LM-3S is no longer a locomotive, it will be an accessory module (like the AM-1). Look in the accessories page to find the missing one. The other one, look at the Module information page to see what's loaded into it (LM-3S rev 2.?? or LM-3S Accessory rev 2.07). At work atm so can't provide any screenshots for you.

- Tim

Navigation

[0] Message Index

[#] Next page