RailPro > RailPro Specific Help & Discussion

An alternative Keep-Alive possibility

(1/1)

JeffShultz:
Okay, I know about, and have, wired KA4's into LM-3(S) modules. And it works, although the KA4's are a bit on the bulky side.

However - Has anyone tried one of the new TCS motherboards? http://tcsdcc.com/wowdiesel/motherboards with a 21-pin adapter and an LM-anything? They've got the capacitors built into the motherboard, so there wouldn't be any messing around with that wiring.

I have to admit, I hope Tim has a 21-pin LM-4(S) on the drawing board at least. With these TCS products and a true, low-profile, 21-pin locomotive module, wiring issues would likely drop to nothing. I admit that I dislike having to hardwire decoders into locomotives that were set up with a motherboard in mind - which I have to do with locomotives such as the P2K GP9, since there just isn't enough clearance room above the original motherboard.

I need to open up one of my Genesis GP39-2's (anyone want to buy a 1st Gen Tsunami?) and see how I could get everything to fit with a http://tcsdcc.com/1616.

William Brillinger:
Jeff, check out this discussion: https://rpug.pdc.ca/index.php/topic,585.0.html

G8B4Life:

--- Quote from: JeffShultz on May 24, 2018, 05:57:17 PM ---I have to admit, I hope Tim has a 21-pin LM-4(S) on the drawing board at least.

--- End quote ---

I hope that too Jeff; there are quite a few that would like to see it. I'd suggest taking that hope to Tim Ring directly and letting him know; I'm not sure he truly knows where the market is heading with decoder plugs. I know adoption of the 21 pin decoder has been slow in the US like it had been here, but here, everything, and I do mean everything since several years ago is released to take a 21 pin decoder. Even re-releases have been getting upgraded boards in them that take 21 pins. I see the same will eventually happen in the US as well;

- Tim

JeffShultz:
Bill,

Thanks for that link - it answers all my questions, and even a couple I didn't have.

The most important part being that the keep-alive functionality of the boards will not work with the LM-3(S) as currently configured.

Rats.

William Brillinger:

--- Quote ---Rats.
--- End quote ---

Right. :(   

I have been considering making custom harness that would handle it though. I wish I had more time to dedicate to it.

Navigation

[0] Message Index