RailPro > RailPro Specific Help & Discussion

Large Scale Power

<< < (4/4)

Alan:

--- Quote from: Dean on June 30, 2018, 12:49:28 PM ---You can manually set the stall current for a locomotive. Without the hand controller in front of me, I couldn't tell you how. But I have done it while experimenting with all the capabilities of the RailPro system.

--- End quote ---

Well I'll be danged. You made me curious so I had to go look. So in the habit of using Auto Set I have never done it any other way. Doubt I will have a need but nice to know the option is there.

To Dean's point, don't use the manual measurement Ohm's Law method to set the RP stall current. It won't be correct.

Navigation

[0] Message Index

[*] Previous page