RailPro > RailPro Specific Help & Discussion

Older Bachman Not DCC Ready Steam Locomotives

(1/2) > >>

drisdon:
I found a very affordable older Bachman 2-6-0 ($30) for my son which I was hoping to install Railpro into, but when it comes to steam I'm pretty clueless.  It appears the locomotive only picks up power in the 3 drivers which makes me think it may not run very reliably.  The frame is in halves and isolated with some plastic spacers, I cannot figure out how or where I would add the wiring for the motor and the driver contacts. The Railpro module and speaker would definitely get located inside the tender, but  is it worth spending the time installing Railpro in this older locomotive or should I just find a DCC ready one, like the Spectrum 2-8-0?

Thanks,
Dan Risdon

Alan:
If the motor is isolated from the frame is there any reason why you cannot connect the LM right at the motor leads?

MtRR75:
While you are installing RailPro, it would be a good idea to add electrical pick-ups to the tender.  The redundancy will give you a much smoother running locomotive.  You may have to change out the tender wheel sets with ones that pick up on one side and are insulated on the other side.

KPack:
I feel your pain Dan.  I'm trying to install Railpro in a very old brass steamer....it's a nightmare.  I have a feeling that the pickup will be very spotty on it as well, but I'm not sure how to overcome that in a brass locomotive.

Carter:
NEW $70.00
HO-Gauge - Bachmann - Pennsylvania Alco 2-6-0 Steam Locomotive (DCC Ready)

EBAY: lisbesthobby

Navigation

[0] Message Index

[#] Next page