RailPro > RailPro Specific Help & Discussion
Ditch lights
jjwdadof4:
I just got the new 911 first responders loco and put in the module in everything works fine except the ditch lights on the rear am I doing something wrong or is there wires I need mess with
Josh
Alan:
See if either of these help you. Both are Tim's fine work.
https://rpug.pdc.ca/index.php/topic,647.msg5025.html#msg5025
https://rpug.pdc.ca/index.php?topic=207.msg1141
G8B4Life:
I really need to update that ditch light guide one of these days ::)
Josh,
A little more info would be good. I'm not sure what the problem is for you as you don't say what the ditch lights are not doing that they are supposed to (or you want them to) do.
- Tim
jjwdadof4:
Tim- they don't even come on
Josh
KPack:
You need to hook up the rear two function wires (off the 6-pin harness) to power the rear ditchlights. If you plugged the LM into the 9 pin harness on the board, but didn't do anything with the 6-pin on the LM, then you only have 4 of the 6 functions hooked up. The four functions will control the headlight, rear light, and front ditchlights. The additional two are required for the rear ditchlights.
You will need to either solder these to the board (not sure if it has pads for that....need a picture), or solder the wires directly to the rear ditchlight wires WITH a resistor. Otherwise you will blow the bulbs immediately. I'm assuming these are still Athearn's bulbs and not LEDs??
-Kevin
Navigation
[0] Message Index
[#] Next page
Go to full version