RailPro > RailPro Specific Help & Discussion
RailPro Proxy | CGNAT workaround
faithie999:
thumbs up! let me know if you got my PM. not sure it went properly.
G8B4Life:
I guess I should provide an update to this...
It works. I did have to go back and recode part of it to work around Windows ASLR which I hadn't considered at the time when it didn't work for Ken the first time but after that Ken reported he successfully downloaded a couple of LM updates without issue. I don't know if he's applied those updates and all is good there though.
Ken, I've also gone back in and changed the communication code so the unresponsive button shouldn't happen any more. I'll let you know when I upload the updated version, I'm in no hurry though as I work on trying to improve the proxy to be better as well.
- Tim
faithie999:
Huge congrats to Tim for getting this done!!
Tim--the other day I updated an LM-3S without any error message, but I just checked and the HC says the LM is at V 1.00. It is very possibly operator error. I'll re-download the update and try again.
G8B4Life:
Are you sure you weren't looking at the hardware revision number of the LM-3S? Unless you downloaded and installed the Accessory firmware for the LM-3S (which is at version 1.00) there is no way you could have downloaded and installed version 1.00 of the regular LM-3S firmware.
- Tim
faithie999:
you're right. at the bottom of the info page for that decoder, I was looking at the line which says "LM-3S-IVT1637, Rev. 1.00". but the important line is the one above that--"Program--SW1041, Rev. 2.12"
Navigation
[0] Message Index
[*] Previous page
Go to full version