RailPro User Group
RailPro => RailPro Specific Help & Discussion => Topic started by: Tommy Mac on December 01, 2017, 12:01:46 PM
-
I have a few questions about installation of a LM-3 in a atlas B23-7. I comes from the factory with an NMRA 8 pin connector. Looking at the instructions it says to install an adapter harness but doesn't have a diagram of which wires go where? Any help would be appreciated.
-
If you buy a pre-made 8 pin to JST 9-pin adapter, it should work fine as is. The only concern is orient the 8 pin correctly when you plug it in. It can go either 1 of 2 ways. The orange wire is pin 1 and you need to figure out which hole it goes in. It's usually marked in some way on the board. If you google it, there is a lot of information on how to orient correctly.
http://www.dccwiki.com/8_Pin_DCC_Plug
Good luck!
Chris
-
Thank you Chris for the help. I didn't think to look at other manufacturer!
-
The 8-pin plug orientation may be specific for DCC decoders, but I have found that with RP, depending upon the way the circuit board is wired, the orientation doesn't really matter. However, in some locomotives the headlight may not work if it isn't in the appropriate orientation for that loco. In that case, just reverse it. Our site host, Bill, sells the correct WH-9 harnesses in his web store.
http://pdc.ca/rr/catalog/products/ring-engineering--railpro/13
-
The WH-9 is not the 8 pin to 9 pin harness. It is a hardwire harness only with the 9 pin connector only.
I do have the T-1R 8 to 9 pin harnesses on hand.
I will bring in an assortment of other harness options for January and add them to my website.
-
Oops! My bad. I could have sworn you were offering the 8-9-pin ones. :o
-
I just looked in my stock drawer.
If you are looking for the T-3.5" 8 to 9 pin, I have 2 available. They are $9 US each including shipping.
T-3.5 - http://tcsdcc.com/Zen/index.php?main_page=product_info&cPath=63_18&products_id=113
The T-1R 8 to 9 pin is a 1" reversed harness. I find they are oriented better for many installs.
I have 10 of them on hand. price is also $9 US each including shipping.
T-1R - http://tcsdcc.com/Zen/index.php?main_page=product_info&cPath=63_18&products_id=409
Feel free to contact me at billy@pdc.ca if you want to order any of these.
-
Ok, wiring harness stock is ordered! They should be here by December 8th.
Here is all the info:
http://pdc.ca/rr/catalog/product/harnesses-keep-alives-and-other-accessories/63