RailPro User Group
RailPro => RailPro Specific Help & Discussion => Topic started by: rsmproductions on April 27, 2025, 08:59:10 PM
-
I think I've posted previously that my LGB Forney has been working beautifully for the past few years, and up until December when it started to malfunction. The engine might travel 10 - 15 feet then stall. Sound was still working on the RailPro. So, I took the powered trucks and cleaned the contacts with an electric contact cleaner spray. I put the engine on some rollers that I have and it seemed to work well. I left everything alone until this past week and decided to put the engine on my trestle (it's the cleanest part of my mainline) and was dismayed that the engine only traveled 10 feet before stopping. No voltage reading on the handheld...
So question...would resetting the RP module be of any help before I tear into the engine? Also an FYI that the RP module is housed in the boiler. It's run great for several years now so am not sure where to start...so hence the resetting question.
Thanks,
Richard
-
I don't believe resetting the module will do anything of use in this situation, all resetting can do is reset any settings that you've changed from the default install of the module. As far as I know resetting doesn't "factory reset" anything to do with the module firmware (I suspect that you'd have to re-download the modules firmware to accomplish that).
It certainly can't hurt to reset the module though, you'll just have to re setup all your changes again.
- Tim