RailPro User Group
RailPro => RailPro Specific Help & Discussion => Topic started by: TJMac on November 06, 2025, 10:35:21 AM
-
Using RailPro to run 2 rail O scale I'm a little concerned 4amps isn't enough as I have several Atlas engines that draw just over 1.2amps each. A consist of three engines would be pushing it. I decided to try a Mean Well LRS-100-15 turned up to 16v for a total output of 112 watts (double the PWR-56). When I run this through the PWR-56 I'm still only seeing 14v at the rails. Hooking the Mean Well direct to the rails and I see the full 16v (plus/minus).
That said, does anyone know if it's possible to adjust the voltage regulator in the PWR-56? Is it even worth messing around with it?
(http://[attachment id=1 msg=12102][/attachment])
-
I have a similar set-up for my HO layout (different unit than your Mean Well), but I'm pretty sure I have mine BETWEEN the PWR-56 and the layout. I'll try and get a photo tonight.
-
As promised, here is my set-up. The Red and White wires go to the track (I really need to remember to attach those to the upright in the photo...)
-
With those different separate power supplies, do you even need to use a PWR-56 at all in the circuit? It’s not like there is any encoded signal being put onto the rails like DCC.