RailPro User Group
RailPro => RailPro Specific Help & Discussion => Topic started by: rmower on November 01, 2020, 08:56:43 AM
-
I am installing a ring receiver into a large scale Bachman Climax and am having trouble with getting the headlights to operate. I connected the output 1 and 2 to the Fled and Rled wires on the adapter board but can't get any response. I have all the programming set and tried the light swith in both DC and DCC positions. Has anyone done an install in one of these engines using the adapter board?
-
I'm not certain about the Climax, but on other Bachmann Large Scale locomotives with the socket like the K-27 and C-19, you must also supply +5V to the lighting/effects buss. If you leave the factory boards intact, this will be provided by the board if there is at least 9Volts on the track, or if a voltage source is connected to the battery input.
Iv'e wired C-19's for R/C both with and without the factory boards and can dig up the pin-outs I used if you want them. Should be the same with RailPro.