RailPro User Group
RailPro => Finished RailPro Installation Examples => Topic started by: JRad on December 05, 2020, 06:13:31 PM
-
Prior to purchasing RailPro I was using a 2.4Ghz system with a Phoenix sound card. I'm a sound nut, so I replaced the small stock speaker with an enclosed oval speaker salvaged from a sound bar. This required removing the tender weigths and circuit boards. It was a complicated install with 4 different components plus battery. By comparison, my RailPro install is much simpler, nothing but an LMS-3-G was need to implement all of the locomotives features. It worked out so well, I did a second C-19 with the same speaker and RailPro configuration.
Here are some install photos before putting the tender shell back on...
(https://lsc.cvsry.com/Post2020/RailProC19-05.JPG)
(https://lsc.cvsry.com/Post2020/RailProC19-06.JPG)
(https://lsc.cvsry.com/Post2020/RailProC19-07.JPG)
And some screen shots of the simulator showing the buttons I set up...
(https://lsc.cvsry.com/Post2020/RailProC19-03.JPG)
(https://lsc.cvsry.com/Post2020/RailProC19-04.JPG)
I'm happy to answer any questions about this install.
-
Just for comparison... This is how it looked with the old system. Even with good wire management, it's a rat's nest!
(https://lsc.cvsry.com/Post5/C-19_Sound_RC-16.JPG)
(https://lsc.cvsry.com/Post5/C-19_Sound_RC-18.JPG)
To say RailPro simplified this installation is an understatement!