RailPro User Group

RailPro => RailPro Specific Help & Discussion => Topic started by: Dean on July 24, 2016, 12:02:07 AM

Title: AM-1
Post by: Dean on July 24, 2016, 12:02:07 AM

The AM-1 can operate two wire snap switches. Does anyone know what the voltage is that is being applied to the switch coils? Is it the same as the power supply?

Thanks,
  Dean

Title: Re: AM-1
Post by: G8B4Life on July 24, 2016, 02:01:05 AM

I'm not sure anyone here owns one. In that case my best guess is about half a volt less than what the power supply supplies to it.

Anyone own one and can measure the output?

- Tim

Title: Re: AM-1
Post by: Dean on July 28, 2016, 10:57:07 AM

The reply from Ring:

"The output is essentially the input voltage to the module. So if you connect a PWR-56 to the AM-1 the AM-1 will output about 14 Volts to the switch."