Author Topic: Large Scale C-19 - A different approach  (Read 5303 times)

JRad

  • Conductor
  • ****
  • Posts: 115
Large Scale C-19 - A different approach
« on: December 05, 2020, 06:13:31 PM »
Prior to purchasing RailPro I was using a 2.4Ghz system with a Phoenix sound card. I'm a sound nut, so I replaced the small stock speaker with an enclosed oval speaker salvaged from a sound bar. This required removing the tender weigths and circuit boards. It was a complicated install with 4 different components plus battery. By comparison, my RailPro install is much simpler, nothing but an LMS-3-G was need to implement all of the locomotives features.  It worked out so well, I did a second C-19 with the same speaker and RailPro configuration.

Here are some install photos before putting the tender shell back on...








And some screen shots of the simulator showing the buttons I set up...





I'm happy to answer any questions about this install.
« Last Edit: December 05, 2020, 06:44:49 PM by JRad »

JRad

  • Conductor
  • ****
  • Posts: 115
Re: Large Scale C-19 - A different approach
« Reply #1 on: December 05, 2020, 06:48:00 PM »
Just for comparison...  This is how it looked with the old system. Even with good wire management, it's a rat's nest!





To say RailPro simplified this installation is an understatement!