Author Topic: Scale Trains Tier 4 Install  (Read 113 times)

CampbellRice

  • Fireman
  • **
  • Posts: 10
    • View Profile
Scale Trains Tier 4 Install
« on: October 07, 2017, 09:27:08 AM »
I just purchased a new Scale Trains Tier 4 Gevo. I have not taken it apart as of yet but I notice the instructions say it has a new LokSound decoder that has dip switches on it. Has anyone looked at how to install a RailPro into this unit yet?
My eyes and electrical experience does not exceed much past plug and play.

nodcc4me

  • Conductor
  • ****
  • Posts: 284
  • RailPro Fan
    • View Profile
Re: Scale Trains Tier 4 Install
« Reply #1 on: October 07, 2017, 02:59:18 PM »
I haven't done one of those, but you will most likely have to remove the decoder and hard wire it to take advantage of all the features of RailPro. The speaker is already in there but you would need to wire that as well.
Al

Run your train, not your brain. Get RailPro. It's a no-brainer.

Viper

  • Fireman
  • **
  • Posts: 14
    • View Profile
Re: Scale Trains Tier 4 Install
« Reply #2 on: October 17, 2017, 08:22:14 AM »
do they also have the 9pin to 21 connector like the ST SD40-2's ?
Ed