RailPro > Finished RailPro Installation Examples

Rapido Dash 8 40CM

(1/3) > >>

BruceRogers:
Here's the Rapido CN Dash 8 40CM I put a module in. I used a TCS 3.5" 21 to 9 pin harness and ran the speaker wires up the side of the circuit board in the fuel tank to 2 iPhone 4S speakers which Rapido have clips for inside the body.
The downside is that the cover for the fuel tank won't fit back on in it's current form. I'm planning to modify the catch to reduce its depth. As of now the module just sits on the ledge inside the tank.
attached is a couple of photos of the LM3S in the fuel tank.

TomO:
Other than the latch any issues? Got my 2 last week and have been procrastinating.
Thanks for sharing
TomO

BruceRogers:
Not Really. I should point out that using the 9-21 pin TCS harness the number lights won't work. The green wire will control the ditch lights but the violet wire has nothing to control. I might wire them directly in the future, but it's not a deal breaker for me that they don't work.
I've since cut the fuel tank cover clip right off. It's a nice press fit and seems it'll have no problem staying put for now.

TomO:
Thank you

CampbellRice:
Good info as I have one to do tomorrow. Where were the speaker wires located?

Navigation

[0] Message Index

[#] Next page