Author Topic: Two locos, one module -- Electrical current ratings for LM?  (Read 1186 times)

ON28

  • Conductor
  • ****
  • Posts: 256
What is the maximum amp rating for an LM? I run HO with motors up to about 1A stall current or less. Can I hardwire two locos to be controlled by one LM? I didn't see this info on RE site.
« Last Edit: July 12, 2019, 11:01:20 AM by ON28 »

G8B4Life

  • Signalman (Global Mod)
  • Conductor
  • *****
  • Posts: 1192
  • I'll think of a catchy tag line one day
Re: Electrical current ratings for LM?
« Reply #1 on: July 11, 2019, 08:10:00 PM »
From one of our older threads...

Quote
The max stall current of a LM-2 is 2.0 amps.  The continuous running current should be less than 1.0 amp. The LM-2 motor output is short circuit, overload, and module over temperature protected.  So if you connect a motor that is too big for it to drive it will turn off and report one of the above faults.

Yes, you could hardwire two locos to be controlled by one LM (we have members who are/will be using them in a dual motor setup but that two motors per locomotive) but you'd definitely need to be careful of how much current you'll draw. I'd say give it a shot, even for just the experiment value.

- Tim

ON28

  • Conductor
  • ****
  • Posts: 256
Re: Electrical current ratings for LM?
« Reply #2 on: July 11, 2019, 09:51:40 PM »
Thanks, I got the same info from Ring today.