Author Topic: PBM-2 Installation  (Read 1403 times)

Monte27ONWRR

  • Fireman
  • **
  • Posts: 3
  • Oregon & Northwestern
PBM-2 Installation
« on: September 30, 2020, 07:21:06 PM »
It has been over 6 month since the PBM-2 was released, has there been any direction on the rectifier / adapter board for the LM-S(2) installation?

Installation
IMPORTANT: You must use adapter board
(sold separately) for LM-2(S) or LM-1 modules.
You do not need an adapter board for LM-3(S).
LM-3(S) can be connected as shown below.

I have looked on the railpro site for the adapter board for my LM-2(S) modules and I cannot find it mentioned or listed other than the Installation note. Where can I find the adapted board so I can figure out if it and the PBM will fit into my trio of ONWRR AS-616's.

Thank you

G8B4Life

  • Signalman (Global Mod)
  • Conductor
  • *****
  • Posts: 1192
  • I'll think of a catchy tag line one day
Re: PBM-2 Installation
« Reply #1 on: October 01, 2020, 01:27:44 AM »
The adapter board is not available yet as far as I, or probably anyone, knows. Ring seems to have gone very quite since the release of the PBM-2 (pandemic related?).  Your best course of action might be to email Ring and ask when he thinks it'll be available.

While I don't have any PBM-2's (waiting for the exchange rate to significantly improve) I too am waiting to see the adapter board.

- Tim

William Brillinger

  • Dispatcher (Admin)
  • Conductor
  • *****
  • Posts: 1324
    • Precision Design Co.
Re: PBM-2 Installation
« Reply #2 on: October 01, 2020, 05:58:28 AM »
Good question - I'll check into this!
- Bill Brillinger, RPUG Admin

Modeling the BNML in HO Scale, owner of Precision Design Co., and RailPro Dealer.


William Brillinger

  • Dispatcher (Admin)
  • Conductor
  • *****
  • Posts: 1324
    • Precision Design Co.
Re: PBM-2 Installation
« Reply #3 on: October 03, 2020, 02:42:19 PM »
My question: "Is the adapter board for the PBM to LM2 available?"

And Tim Ring's reply: "Not at this time. It is on our to do list."
- Bill Brillinger, RPUG Admin

Modeling the BNML in HO Scale, owner of Precision Design Co., and RailPro Dealer.


Monte27ONWRR

  • Fireman
  • **
  • Posts: 3
  • Oregon & Northwestern
Re: PBM-2 Installation
« Reply #4 on: October 04, 2020, 05:35:32 PM »
Thank You