RailPro > RailPro Software Updates
Heavy Steam ULT
nodcc4me:
You should, Kevin. They’re a lot of fun to run.
I only had a minute to spend with the new file. I’ll mess with it tomorrow and try adjusting the chuff rate.
G8B4Life:
--- Quote from: nodcc4me on February 06, 2021, 04:07:21 PM ---It is very large
--- End quote ---
Not large, just very slow. I'll complete today an analysis of the time taken as I've always wanted to do it. I may or may not post it, I haven't decided yet but I think you'd all be a little shocked at the findings.
- Tim
KPack:
Yes, the file sizes aren't big. But transfer is very slow....I'm assuming because how the programming is written. Radio transfer should be near instantaneous, so it's not a limitation of the signal but rather a limitation of the software.
Comparatively speaking the Heavy Steam ULT is larger than most (or all) other files.
-Kevin
G8B4Life:
Your assumption would most likely be correct. The only thing that is not known is how fast can the PIC and flash memory in an LM be written to, that would set the maximum transfer rate as I wouldn't think an LM includes RAM to put a buffer in.
--- Quote ---Comparatively speaking the Heavy Steam ULT is larger than most (or all) other files.
--- End quote ---
Almost, many of the diesel ULT prime movers are bigger.
- Tim
t4hrtrh:
Quick Intro. My name is Tom I jumped on the RP wagon last year.
I will give a better into in the proper section later.
Just wanted to comment on the new Heavy Steam. WOW.
I do Large Scale and was waiting on this for my Hudson. I put it all on the bench last night and finished it this morning. I have a 4 Ohm 2.5" speaker hooked up to it. Let's just say I am in the dog house.
I cranked that baby up and woke up the wife!!!!! The neighbors are going to love this.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version