Author Topic: Control taken away!  (Read 8750 times)

ON28

  • Conductor
  • ****
  • Posts: 260
Control taken away!
« on: December 20, 2021, 04:56:39 PM »
My Intermountain F3 was running fine. I unlinked it from a consist, and ran an update of the LM3-S software, not noticing it had already been updated. When I then selected the loco on the HC, its page came up but immediately prompted me that buttons had been revised and to go to Adjustments and save. I exited back to the loco page but when trying to access Adjustments, I got a message "Control taken away!" I could not acquire or re-consist it and got a "Bad lead loco" message. I tried clearing the loco from the HC and re-acquiring, but got the same messages.

Any suggestions here are gratefully accepted before I call Ring. Thanks!
« Last Edit: December 20, 2021, 05:04:31 PM by ON28 »

nodcc4me

  • Conductor
  • ****
  • Posts: 688
  • RailPro Fan
Re: Control taken away!
« Reply #1 on: December 20, 2021, 05:35:55 PM »
It's probably just a glitch. Try unlinking any other locos that are in the consist. Then power off the system and turn it back on and try to access the LM3-S again.
Al

Run your train, not your brain. Get RailPro. It's a no-brainer.

ON28

  • Conductor
  • ****
  • Posts: 260
Re: Control taken away!
« Reply #2 on: December 20, 2021, 08:43:58 PM »
It's probably just a glitch. Try unlinking any other locos that are in the consist. Then power off the system and turn it back on and try to access the LM3-S again.

Yes, seemed to be a glitch, all's well now. Thanks.