« previous next »
Pages: [1]

Author Topic: P2K SD60 install  (Read 6393 times)

CPRail

  • Conductor
  • ****
  • Posts: 226
  • You know, sometimes I amaze even myself.
P2K SD60 install
« on: February 04, 2017, 06:17:14 PM »
Hi Group,

Has anyone installed a RailPro module into a P2K SD60? I have a pair that I would like to convert, and I just cracked one open and I'm not sure if I can toss the board or not. With that huge "pull the walls down" weight, there isn't a ton of room to play around in without tossing the board.

Thoughts?
Logged
Ian Lisakowski
Modelling CP Rail & VIA in the early 80's

Josephbw

  • Conductor
  • ****
  • Posts: 251
Re: P2K SD60 install
« Reply #1 on: February 04, 2017, 09:49:39 PM »
I've installed 22 LM's in my engines, and so far I've only left one board in. Just make sure you know where all the wires go before you pull the board, then hard wire it. But none of those engines were the SD60 though (too new for my layout).

Joe
Logged

BruceRogers

  • Engineer
  • ***
  • Posts: 97
Re: P2K SD60 install
« Reply #2 on: February 11, 2017, 12:13:34 PM »
Proto SD9 LM-1.jpg
This is a photo of a pre Walthers Proto 2000 SD9. I toss the board as it's of no use, the only thing on it is diodes for the lighting.
I then hardwire in the 9 pin JST harness. You will need to add resistors to for the lights if you don't use a 12-14 volt bulb. All my P2K units with the newer LM-2/2S modules were done in a similar manor.
Logged
Pages: [1]
« previous next »