I've made the plunge and installed our first railpro system in the g scale layout. So far all is good! A few hang-ups requiring minor changes to fix. (Reading directions helps, lol).
I searched the forum and had no luck, if there is a post be share the link.
On to hooking up the circuit board for the smoke generator. Out of the circuit board is 5 volts to the heater/generator. The analog input that enabled the smoke before says 22 vdc. Should my 5vdc railpro output just be wired to the 22vdc terminals? I'm assuming this is just an enabler as the 5vdc output to heater is another terminal strip from the board.
Thanks
