Author Topic: AM-1 BATTERY POWER  (Read 8458 times)

mcbunton

  • Fireman
  • **
  • Posts: 26
AM-1 BATTERY POWER
« on: March 03, 2021, 11:33:51 AM »
Dead rail outdoor layout, what do any of you use to power your AM-1?  Max input says 16 volt, but 12 volt battery are cheaper and more plentiful?  Newbie here looking for help.  Thanks in advance!

Alan

  • Conductor
  • ****
  • Posts: 1073
    • LK&O Railroad
Re: AM-1 BATTERY POWER
« Reply #1 on: March 04, 2021, 08:00:55 AM »
Other than the fact you will have to recharge it frequently, sure, why not use a 12v battery. AM-1 will work on 12v.
Alan

LK&O Railroad website

When I was a kid... no wait, I still do that. HO, 28x32, double deck, 1969, RailPro

KiloWhiskey

  • Engineer
  • ***
  • Posts: 61
  • Kevin W.
Re: AM-1 BATTERY POWER
« Reply #2 on: March 04, 2021, 06:49:32 PM »
Good excuse to install a solar panel trickle charger doo-hicky
Kevin


In my defense, I was left unsupervised....

donsweet

  • Fireman
  • **
  • Posts: 6
Re: AM-1 BATTERY POWER
« Reply #3 on: March 05, 2021, 09:21:39 AM »
Hi Guys, for a outdoor layout, use a Duracell lead acid battery. 12V 4.5AH. Buy them at Battery Plus. It will last for years. Place inside a building with the AM-1 and plug into the AM-1 when you are operating.

Don

Gibs

  • Engineer
  • ***
  • Posts: 82
Re: AM-1 BATTERY POWER
« Reply #4 on: March 05, 2021, 03:10:04 PM »
Or you could use 3 x 6V SLA Batteries wired in series for 18V, use a Solar setup for charging each battery at either 6V seperatly via each one on a change over isolator switch or combined at 20V. Use a small stepdown from 24V to do so. (I can't recall if anyone makes a suitable 18V charger). The AM-1 can then run off another small stepdown to the required 16V. It should also be noted that most electronic devices by there very nature can have a variance of around 12 percent in supply voltage but it's still best practise to supply the recommended voltage.
« Last Edit: March 05, 2021, 03:19:55 PM by Gibs »
Cya Down The Line.

Gibs

  • Engineer
  • ***
  • Posts: 82
Re: AM-1 BATTERY POWER
« Reply #5 on: March 12, 2021, 10:39:27 PM »
Personally though, I'd just install an outdoor weather proof power point and plug in a 16V DC power pack and cover it all up with a building!
But that's just me.
Cya Down The Line.

JRad

  • Conductor
  • ****
  • Posts: 115
Re: AM-1 BATTERY POWER
« Reply #6 on: March 17, 2021, 02:41:10 PM »
I'm also dead rail outdoors (and indoors), but I sue my rail as a power buss for building lights. I have 12VDC running through the rail on a timer so the buildings shut off during daylight hours.  If you used rail joiners when you built, it may be possible or you to d the same to power your AM-1.

On the other hand, your thought of using a battery is probably the simplest.